Rapid-air CUT-TO-LENGTH WITH MULTI-STROKE Manual do Utilizador descarregar pdf (Página 27)

Cut to Length with Multi Stroke Program

Material feeds off Edge guides not set Set edge

guides

center properly

Material not centered Center

material

in feed

No automatic cycle No cutter returned signal Check limit

switch

input to

servo control

Controller fault Check

lights on P.C.

Servo fault Check

lights on drive

Program error Check

parameters

Servo squeals while Servo velocity gain Consult

factory

in position too high

Belt too loose or tight Readjust

belt tension

file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (26 of 66) [12/10/2001 3:44:57 PM]

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

Sem comentários

Rapid-air CUT-TO-LENGTH WITH MULTI-STROKE Manual do Utilizador Página 27