Rapid-air MINI-SERVO FEED: MS2, MS4 & MS8. 115vac, 1ph, Manual do Utilizador

1RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.commini-serv

10NEVER – Put screwdrivers or foreign materials in feed rolls NEVER – Hold onto material as it is being fed through the servo NEVER – Wear neck

11ALL SALES BY THE COMPANY ARE MADE SUBJECT TO THE FOLLOWING TERMS AND CONDITIONS. PLEASE READ. WARRANTY - The Company warrants, for a period of one

12mini-servo PArTs illUsTrATion (see lisTinG on nexT PG.)

136261605958575655545352515049484746454443424140393837363534333231302928272625242322212019181716151413121110987654321mini-servo PArTs lisT (see diAGr

14mini-servo ConTrol Assembly123456789101112Item Qty. Part No. DescriptionSTAND ASSEMBLYCONTROL BOX FRONTDRIVEREGEN RESISTORPOWER

15MS Series Servo

16MS2 Servo Adjustable Mounting Bracket

17Keypad

18MiniServo Feed Wiring Schematic – 115 vac, 1 ph, 60 HzNote: Do not attempt to rewire servo unit.

2INTRODUCTION ...

3The MS-Series servo has many features found in the more expensive models. Some of its features are:Input: 120 VAC, 50/60 HzAmperage required at i

4The gear box is located within the feed body on the same side as the roll release handle. It has a non-lubricated gear box so it is essentially mai

5feed rolls, PiloT releAse sToP, enTrAnCe GUideA pilot release stop may be added for higher speeds. The pilot release stop is mounted next to the ro

6The intent of this section is to familiar-ize the operator with the flow of the program and what to expect with each key press. Each program screen

7oPerATor inPUT seCTion (ConTinUed)Operator Input Section The following screen is displayed when the period is pressed while the “Main Selection menu

81234.04.14.24.34.44.54.64.74.84.9567.17.288.19101214.114.215.115.216TroUbleshooTinG (7.3.1 fATAl fAUlT error Codes)Error # Status Display

9Watchdog (DSP)Watchdog (HPC)No compensationInvalid velocity controlEncoder not initialized on attempt to enableEncoder initialization failureAuto-co