Rapid-air MULTI-STROKE CONTROL Manual do Utilizador

1RAPID-AIR CORPORATION4601 KISHWAUKEE ST. • ROCKFORD, IL 61109-2925Phone: (815) 397-2578 • Fax: (815) 398-3887 • Web Site: www.rapidair.commulti-str

10ALL SALES BY THE COMPANY ARE MADE SUBJECT TO THE FOLLOWING TERMS AND CONDITIONS. PLEASE READ.WARRANTY - The Company warrants, for a period of one

2INTRODUCTION ...

3The Multi-Stroke Control, when coupled with a Rapid-Air feed, increases the feed length by up to 9 times the original feed length capability.The con

4There are two switches on the board for changing the operation of the cut-to-length.1. The first switch is a bat or toggle switch. It is locate

5The air feed needs very little maintenance. The most important part to watch is the air. Too much oil or water in the air can cause the air feed t

6Feed and stock clamps work, but slide block does not move when actuating valve is depressed.Excessive leakage of air from exhaust hole beneath speed

7Feed has difficulty pushing last part of progression.Over feeding.Under feeding.Slide block will move out okay, but will not return without hesitatio

8ISOLATED NORMALLY OPEN CONTACT PROVIDED TO CUSTOMER. THE CONTACT WILL CLOSE WHEN THE PRESET COUNT OF THE MULTI-STROKE UNIT HAS BEEN REACHED (MAX 12

9